Dice Tower with Storage Tray - Pointed Arch Design, 8 Dice Pockets, No Supports

Über dieses Modell

Fair rolls and a tidy table: a slim dice tower with a matching rolling tray that also stores your whole dice set. Drop a die in the top, it bounces off two internal baffles and a solid exit ramp, then rolls out through the pointed-arch opening into the tray. The tower slots into a socket at the back of the tray, flanked by two blocks with 2 x 2 round pockets each - 8 pockets of 28 mm, enough for a full 7-dice polyhedral set plus one spare. The dice stand slightly proud, so they are easy to grab. Design: one consistent pointed-arch language - arch-shaped exit with a bevelled frame, recessed arch panels on all four sides, a crown band at the top, rounded corners and chamfered edges everywhere you touch. Print-friendly: every downward face is at 50 degrees or steeper, so both parts print without supports. The tower prints upright; its base is a solid wedge that gives it weight and stability. Size assembled: 220 x 180 mm footprint, 178 mm tall. The channel is 52 x 58 mm and every gap is 28 mm or more, so dice up to about 24 mm pass freely. Parts: 2 (Tower, Tray). Assembly: set the tower into the socket at the back of the tray - no glue, no tools. Lift it out to pack away. Tip: a strip of self-adhesive felt on the tray floor makes rolls even quieter.